Oview

The O-View TT hand-held programmer represents the state-of-the-art in the programming of rolling shutter and sun awning automation systems. Automatically recognising the control unit and thus the automation system to which it is connected, it displays its typical parameters, cutting out the device identification procedure for the maximum speed and convenience.


Once connected, the O-View TT guides the operator through setup of the installation parameters: setting of the electronic limit switches and motor run direction, torque reduction setting, and memorisation of the transmitters and the Nemo and Volo radio control sensors. The settings made appear on the LCD screen for instantaneous checking of the parameters set. The graphic interface of the O-View TT, with intuitive screens and context-responsive menus, allows even absolute beginners to programme the automation system, with no specialist knowledge required.


The O-View TT allows the settings made to be saved for future copying, meaning there is no need to repeat the sequence for subsequent automation systems, ensuring accuracy and time-saving especially on complex installations with a large number of systems. With O-View TT the motor can be programmed to suit the type of awning, rolling shutter or Venetian blind automation system, and specific setups can be created in just a few simple steps.


The O-View TT also manages the memories of the Nemo and Volo radio control sensors, allowing setting of the Sun-Wind trigger levels and sensor on/off in the VOLO and VOLO S models only.


O-View TT

New hand-held programmer with display for Era Mat MA, Era Mat MT, Era Mat MVS, Era Zero MVS motors and Mindy TT3, TT4 and TT5 control units with TTBus technology.



Product# 




OVIEWTT 

Control and programming unit for motors and control units with TTBus, powered by rechargeable batteries. Complete with battery charger and connection cables.

ALA1 

Battery charger (110-230 V ; 50/60 Hz)